Hidden mold in a Conley wall usually traces to a leak or dampness that has soaked drywall and insulation from behind. The work is to stop the water, remove affected material under containment, and dry and clean the framing before rebuilding. Call the number on this page to be connected with a local mold remediation company in Conley.

What happens when you call
You will be connected with an independent local company that serves the Conley area. Expect questions about which wall, how long you have noticed it, and whether there has been a plumbing leak or storm. At the visit, someone should take moisture readings across the wall and the rooms on either side, look at nearby plumbing and windows, and explain where the wet area starts and stops. You should get a written scope before any drywall comes out.
Cost factors
Angi's Atlanta cost guide reports most pros charge $12 to $29 per square foot for mold remediation, and drywall repair at $1,174 to $3,405. The biggest variables are:
- How far the moisture spread inside the cavity
- Whether insulation, baseboards or flooring also have to go
- Containment needs, especially with children or people with asthma at home
- Who handles the rebuild and finish work

Local conditions in Conley
Conley is an unincorporated community on the northern edge of Clayton County, about 8 miles from Atlanta, best known for manufacturing and trucking along US 23/GA 42. Clayton County was among the counties under a state of emergency during the September 2009 floods. Most wall mold here comes from the everyday causes found across the metro: slow leaks in supply lines and drains, rain forced around windows during summer storms, and humid air condensing on cool walls.
For the Clayton portion of Conley, rebuild permits come from Clayton County Community & Economic Development at the P.K. Dixon Building in Jonesboro; if your address falls in another county, check with that county. Renters can contact Clayton County Code Enforcement, which says it does not handle mold directly but may address plumbing problems and leaks behind it.
Before the company arrives
- Shut off water to a leaking fixture if you can
- Pull furniture a few feet away from the wall
- Do not scrub, sand or cut into the stain
- Note when you first saw it and any recent leaks
- Have photos ready if the stain has changed over time
- Clear a path to the water heater, sink cabinets and any access panels so plumbing can be checked
- Keep pets and children out of the room
Mold in Walls & Drywall questions in Conley
Can I paint over a mold stain on drywall?
Will the county health department inspect mold in my walls?
Is black mold inside a wall more dangerous than other mold?
Do I need a permit to rebuild the wall afterward?
More mold services in Conley
Mold in Walls & Drywall nearby
Sources
- EPA: Mold Cleanup in Your Home
- EPA: A Brief Guide to Mold, Moisture and Your Home
- Angi: Mold Remediation Cost in Atlanta, GA
- U.S. Senate Resolution 286 (111th Congress) on the September 2009 Georgia floods (pdf)
- Clayton County: Building Permits and Inspections
- Clayton County: Code Enforcement
- UGA: Georgia County Environmental Health Contact Information (pdf)
- Georgia DPH: Indoor Air Quality/Mold
- Conley, Georgia (Wikipedia)
Last updated: