HVAC mold removal in Rex means locating the moisture in the system, fixing it, cleaning sheet metal parts and replacing moldy duct board or lined duct. A company should show you what it found before quoting the job. Call the number on this page to be connected with a local mold remediation company in Rex.

How does mold get into an AC system in Rex?
Rex sits in eastern Clayton County, about 13 miles from Atlanta, with a historic village center around the Rex Mill. Older homes near the village and newer houses on the surrounding roads both rely on central air for much of the year. Every hour the AC runs, the coil pulls water out of the indoor air. That water should drip into a pan and leave through a drain line. When the pan rusts, the line clogs with slime, or a duct running through a damp crawl space starts to sweat, moisture stays put and mold follows. Clayton County was also among the counties under a state of emergency during the September 2009 floods, and any home where water reached the ducts or unit then deserves a closer look now if it was never fully addressed.
What gets cleaned and what gets replaced?
Hard sheet metal ducts with visible growth can often be cleaned; EPA's duct guidance says cleaning may be worth considering in that case. Fiberglass duct board and ducts lined with fiberglass are another matter. EPA says when they are wet or moldy they cannot be effectively cleaned and should be removed and replaced. The coil and pan are cleaned, the drain is cleared, and wet insulation around the unit is usually bagged out. Any coating a company wants to apply afterward should be named and explained.
Who do I call about permits and leaks in Rex?
Rex is unincorporated, so building permits for addresses in unincorporated Clayton County come from Clayton County Community & Economic Development in the P.K. Dixon Building in Jonesboro, which runs an online permit and inspection portal. Ask your contractor whether replacing equipment or duct runs needs one. Renters with an unrepaired leak can contact Clayton County Code Enforcement at 678-610-4755 or through Click Clayton; the county says it does not handle mold itself, but plumbing problems and leaks may fall under its property maintenance work.

A short local note
Angi's Atlanta cost guide lists HVAC system mold remediation at $3,522 to $11,740, and HomeGuide's 2026 national range for HVAC systems or ducts is $2,000 to $10,000. Georgia has no state mold license, so ask about training and, for rebuilding, check the contractor on GOALS Verify Now.
HVAC & Air Duct Mold Removal questions in Rex
Are ducts in a crawl space more likely to grow mold?
Is a permit needed to replace ductwork or an air handler?
Should the ducts be checked after a flood?
Who should stay away while moldy ducts are being worked on?
More mold services in Rex
HVAC & Air Duct Mold Removal nearby
Sources
- EPA: Mold Cleanup in Your Home
- EPA: Should You Have the Air Ducts in Your Home Cleaned?
- EPA: Homeowner's and Renter's Guide to Mold Cleanup After Disasters (pdf)
- U.S. Senate Resolution 286 (111th Congress) on the September 2009 Georgia floods (pdf)
- Angi: Mold Remediation Cost in Atlanta, GA
- HomeGuide: Mold Removal Cost (2026)
- Clayton County: Building Permits and Inspections
- Clayton County: Code Enforcement
- Georgia SOS GOALS: Verify Now
- Rex, Georgia (Wikipedia)
Last updated: