HVAC & Air Duct Mold Removal in Palmetto, GA

What happens when you call

The number on this page connects you with an independent local mold remediation company. Expect a few questions: where the air handler is, what you have seen or smelled, whether anyone in the house has asthma or a weakened immune system and whether the system is still running. From there, a typical job runs in stages:

1. An inspection of the indoor unit, coil, pan, drain line, blower and the duct runs, often with a camera inside the ducts.
2. A written scope that names the moisture source and lists what will be cleaned and what will be replaced.
3. Containment so dust from the system does not spread through the house.
4. Cleaning of hard surfaces and removal of moldy duct board or lined duct, which EPA says cannot be effectively cleaned.
5. Correction of the moisture problem, sometimes with a heating and air contractor handling the equipment.

What moves the price

Angi's Atlanta cost guide reports HVAC system mold remediation at $3,522 to $11,740. Where a job lands in that range depends on how much duct is affected, the duct material, how much the crew can reach without opening walls or ceilings, how many registers and boots need replacing and whether the blower and coil need deep cleaning. An HVAC test, if you want one, adds $50 to $75 to an air test according to Angi's 2026 national data.

Local conditions in Palmetto

Palmetto is a small city on the southwest edge of Fulton County, about 22 miles from downtown Atlanta, and part of it extends into Coweta County. It was incorporated in 1854 and is mostly urban with a rural fringe. That mix brings older houses near downtown and homes on larger lots farther out, many with ducts in a vented crawl space or attic. The area shares metro Atlanta's long, humid summers and heavy thunderstorms, and red clay soil can hold water near foundations after a downpour. Those conditions push humidity up under the floor, where cold ducts sweat. Because the city spans two counties, check with the City of Palmetto about permits if walls or ceilings need rebuilding after the work.

Checklist before the company arrives

• Clear a path to the air handler, the attic hatch and the crawl space door
• Write down the unit's age and the date of the last service, if known
• Gather photos of growth and any water stains
• Have a list of questions about cleaning versus replacement
• Decide whether you want an independent inspector for clearance